P0619 Generic (SAE) Basic entry

Alternative Fuel Control Module RAM/ROM Error

Updated 2026-10-02 · Computer & output circuits

Severity
Medium
Typical repair cost
40 – 350 EUR
System
Powertrain

What it means

P0619 is a general fault for the Alternative Fuel Control Module RAM/ROM circuit: the engine control module has detected a condition it cannot classify as low, high or open, often because the fault changes during the test.

This entry is compiled automatically from the standard definition and typical diagnostic practice for this type of fault. A detailed, reviewed article is in preparation.

Advertisement728 × 90

Symptoms

  • Check engine light on
  • Engine may not start or runs in limp mode
  • Several unrelated codes stored at once
  • Erratic gauge or warning light behaviour

Common causes

  1. Damaged, chafed or corroded wiring in the Alternative Fuel Control Module RAM/ROM circuit
  2. Corroded, loose or water-damaged connector terminals
  3. Failed Alternative Fuel Control Module RAM/ROM component (sensor, solenoid or actuator)
  4. Poor ground connection for the module or component
  5. Faulty control module driver (rare, confirm all else first)

How to diagnose

  1. Read freeze frame data and note when the code set (cold start, under load, after rain)
  2. Inspect the Alternative Fuel Control Module RAM/ROM connector for bent pins, corrosion and water; wiggle the harness with the engine running and watch live data
  3. Measure supply voltage and ground at the connector with the key on
  4. Check the signal wire for shorts to ground or battery and for continuity to the control module
  5. Test or substitute the Alternative Fuel Control Module RAM/ROM only after wiring and connectors are confirmed good
  6. Clear the code and complete a drive cycle to confirm the repair

Frequently asked questions

Can I keep driving with P0619?

Usually yes for a short time, but expect reduced performance or higher fuel use. Have it diagnosed within a few days.

Will clearing P0619 fix it?

No. Clearing only erases the stored code; it returns as soon as the monitor runs again unless the cause is repaired.