P1189 Manufacturer-specific Basic entry

Engine Oil Temperature Out Of Self Test Range

Updated 2026-10-02 · Manufacturer-specific powertrain

Severity
Medium
Typical repair cost
60 – 500 EUR
System
Powertrain

This is a manufacturer-specific code. Its exact meaning can differ between makes; the definition below follows the most common usage.

What it means

P1189 is stored when the Engine Oil Temperature Out Of Self Test Range signal is electrically valid but does not make sense compared with other sensors or the expected operating range. The circuit is usually fine; the component or what it measures is out of specification.

This entry is compiled automatically from the standard definition and typical diagnostic practice for this type of fault. A detailed, reviewed article is in preparation.

Advertisement728 × 90

Symptoms

  • Check engine light on
  • Rough or unstable idle
  • Hesitation or poor acceleration
  • Increased fuel consumption
  • Possible limp mode with reduced power

Common causes

  1. Engine Oil Temperature Out Of Self Test Range worn, contaminated or out of calibration
  2. Mechanical problem in the system the sensor measures
  3. Air, vacuum or exhaust leak influencing the reading
  4. Wrong or low-quality replacement part
  5. Wiring resistance causing a small voltage offset

How to diagnose

  1. Compare the live Engine Oil Temperature Out Of Self Test Range reading with a known-good value or a second sensor at idle and at 2500 rpm
  2. Check for air, vacuum or exhaust leaks that could skew the reading
  3. Inspect the component for contamination and clean it if the design allows
  4. Verify the part number is correct for the engine
  5. Replace the Engine Oil Temperature Out Of Self Test Range if the reading remains out of specification

Frequently asked questions

Can I keep driving with P1189?

Usually yes for a short time, but expect reduced performance or higher fuel use. Have it diagnosed within a few days.

Will clearing P1189 fix it?

No. Clearing only erases the stored code; it returns as soon as the monitor runs again unless the cause is repaired.