enbgde
U1182 Ford Basic entry

SCP (J1850) Invalid or Missing Data for Primary Id

Updated 2026-10-02 · Network (manufacturer-specific)

Severity
Low
Typical repair cost
50 – 700 EUR
System
Network

This is a manufacturer-specific code. Its exact meaning can differ between makes; the definition below follows the most common usage.

What it means

U1182 is stored when a module receives messages for SCP (J1850) Primary Id over the data bus but the content is invalid, missing or out of sequence.

This entry is compiled automatically from the standard definition and typical diagnostic practice for this type of fault. A detailed, reviewed article is in preparation.

Advertisement728 × 90

Symptoms

  • Several warning lights on at the same time
  • Functions controlled by the affected module do not work
  • Scan tool cannot communicate with one module
  • Gauges dropping to zero or dashboard flickering

Common causes

  1. Blown fuse or no power supply to the SCP (J1850) Primary Id
  2. Poor ground for the module
  3. Damaged CAN/data bus wiring or connector
  4. Failed module
  5. Low battery voltage during cranking or after a jump start

How to diagnose

  1. Check which modules respond to a full system scan and which do not
  2. Verify fuses, power and ground at the SCP (J1850) Primary Id connector
  3. Measure CAN bus resistance between the two bus wires (about 60 ohms with the battery disconnected) and inspect the wiring
  4. Check battery voltage and charging system; low voltage causes many communication codes
  5. Replace or reprogram the module only after power, ground and bus wiring are confirmed

Frequently asked questions

Can I keep driving with U1182?

Yes. The fault does not affect safety or driveability, but it will keep the warning light on and may fail an inspection.

Will clearing U1182 fix it?

No. Clearing only erases the stored code; it returns as soon as the monitor runs again unless the cause is repaired.

Related codes

U1000U1001U1002U1003

Nearby codes in this group